themountdepot.com

NOTE: Mounting hardware to the forklift is not included. 

RAM-E-111-335 Features and Options:

• Warranty: Manufacturer's, RAM Mounts (National Products Inc.), Limited Life Time Warranty.
• Forklift Mount Plate Material: The RAM-335 is black powder coated steel.
• Forklift Plate Capacity: Maximum suggested weight 20 lbs.
• Forklift Plate Description: RAM-335 shown below has many different combination of pre-drilled holes which will match many electronic devices.

NOTE: RAM-335 mounting plate show above with included RAM-E-246 plate with 3.38 inch diameter ball.

• Manufacturer's Description: Sometimes the simplest solution makes the most sense. The new RAM Lift Truck Back-Up Mounting Plate is the ideal way to get a RAM ball attached to most any lift cage or overhead guard.
• Installation: Installation is as easy as attaching the base with ball to one of the plates and then sandwiching the guard or cage between the two mounting plates using the hardware provided.
• VESA Plate Included: RAM-E-246U is a black powder coated marine grade aluminum 4.75 inch square plate with 4x75mm and 4x100mm hole pattern. and 3.38 inch diameter rubber ball. The RAM-E-246 attaches to the RAM-335 forklift mounting plate.
  

        

• Arm Included: RAM-E-201U shown below is the standard sized "E" sized length arm. Black powder coated marine grade aluminum arm is 9.875 inches in length from socket center to socket center and 12.625 inches in overall length. A tightening knob on the side of the arm enables the sockets to clamp firmly to the attached base and mounting plate. The arm allows for easy adjustment by loosening the side knob, a single spring inside the arm opens the sockets, allowing the arm to pivot on the attached plates. This enables the arm and mounting plate to be positioned at various angles allowing the ultimate in position flexibility. Loosen the knob completely and the arm will disconnect from the accessories in seconds!  
  

• Mounting Plate Included: RAM-E-111BU shown below is a black powder coated marine grade aluminum 11 inch by 3 inch rectangular mounting plate with 3.38 inch diameter ball. This plate has pre-drilled holes and can also be drilled into for additional holes.