Home >

Tripod Assembly
Tripod Assembly
 
Price $261.49

STOCK STATUS: In Stock - Ships Next Bus. Day

Free Shipping
Product Code: RAM-TRIPOD1
QTY:

DESCRIPTION
 
RAM-TRIPOD1 shown above (camera not included).

RAM-TRIPOD1 Includes the Following:
  • Warranty: Manufacturer's, RAM Mounts (National Products Inc.), Limited Life Time Warranty.
  • Bubble Level: Built in bubble level and comfortable grips make setup and handling a breeze.
  • Carrying Case: A carrying case is included to house the RAM-TRIPOD1.
  • Dimensions: Three piece telescoping legs with quick release allow the legs to be independently adjusted for uneven surfaces. The tripod adjusts to following heights:
    • Minimum Tripod Height: 21 inches
    • Maximum Tripod Height: 58 inches
  • Hardware Included: Yes. Dual sided threaded screw with 3/8"-16 male and 1/4"-20 male thread attaches to the tripod center column. This can be used to secure cameras and other accessories.

RAM-TRIPOD1 Popular Options (NOT INCLUDED) Below:
  • RAM-202CNSU: Optional single 2.5 inch diameter mount with 3/8"-16 female hole and 1.5 inch diameter rubber ball. This mount attaches to the supplied 3/8"-16 male thread on top of the RAM-TRIPOD-1.


  • RAM-201U: Optional double socket arm allows a 1.5 inch diameter ball accessory to be connected at either end. A tightening knob on the side of the arm enables the sockets to clamp firmly to the attached accessories. The arm allows for easy adjustment by loosening the side knob, a single spring inside the arm opens the sockets, allowing the arm to pivot on the attached accessory. This enables the arm and accessories to be positioned at various angles allowing the ultimate in position flexibility. Loosen the knob completely and the arm will disconnect from the accessories in seconds!
    • Arm Material: Black powder coated marine grade aluminum with plastic twist knob.
    • Arm Length Socket Center to Socket Center: 4.55 inches.
    • Overall Arm Length: 5.625 inches.


  • RAM-202U: Optional 2.5 inch diameter marine grade aluminum mounting plate with 1.5 inch diameter rubber ball. The plate has pre-drilled holes included the AMPS hole pattern. This mounting plate can be used to attach to RAM Tough Tray and RAM electronic holders (RAM-HOL-xxxx).