RAM-VB-109NR RAM Mount Base for Ford F-150

Price $70.49

STOCK STATUS: In Stock - Ships Next Bus. Day

Product Code: RAM-VB-109NR

RAM-VB-109NR vehicle base for the following vehicles:

Ford F-150 (2004-2014)
Lincoln Mark LT (2005-2010)

NOTE: As auto manufacturers redesign vehicle models this base may or may not fit additional models. If you do not see your vehicle listed contact us or complete the product inquiry form by clicking here.

NOTE: Click here for Airbag Safety and RAM Mounting Systems.

RAM-VB-109NR Manufacturer Specifications:

NOTE: Manufacturer specifications can change without notice.

Warranty: Manufacturer's, RAM Mounts (National Products Inc.), Limited Life Time Warranty.
Material: Black powder coated steel.
Seat Configuration: Bucket or bench seat.
Installation: No-drill installation. Attaches to existing seat studs.
Mount/Base Placement: Passenger side floor board, under seat.
- NOTE: Vehicle base will limit seat travel.
Vehicle Base Dimensions:
- Dimension A: 19.25 inches
- Dimension B: 4.5 inches
- Dimension C: RAM-VB-SB4 Vehicle Riser NOT INCLUDED.
- Center to Center Hole Seat Bolt Distance: 11.63 inches
- NOTE: Center to Center Hole Seat Bolt Distance is the center hole distance of the two pre-drilled holes in the vehicle base that line up with the vehicle seat bolts. This distance MUST MATCH your vehicle.
- NOTE: Picture below shows the vehicle base with the RAM-VB-SB4 vehicle riser. The RAM-VB-SB4 IS NOT INCLUDED with the RAM-VB-109NR. Dimensions for A and B are correct.

Instructions

Click here to view the RAM Mount Vehicle Laptop installation video.
NOTE: If your vehicle is equipped with an airbag sensor under the seat disconnect the sensor before installing the vehicle base. (If unsure contact your local car dealer.) The video shown is for installation reference and may show additional or less parts than your vehicle base (RAM stabilizer foot that attaches to the base/lower tele-pole as shown in the video). Simply follow the video without installing these components if your vehicle base does not include these parts. Your vehicle base may connect to the seat track bolts differently than shown in the video. The instructions shown to install the RAM tele-pole system, swing arm assembly and Tough Tray are the same for all RAM No-Drill laptop systems regardless of the vehicle base used.
NOTE: Click here to view Airbag Safety and RAM Mounting Systems (Adobe required).