RAM-VB-181-WEST1 RAM Mount Vertical Universal Mount w/ Swing Arm

Price $272.42

STOCK STATUS: Out of Stock - Email for ETA

Product Code: RAM-VB-181-WEST1

FREE DOMESTIC GROUND SHIPPING!

RAM-VB-181-WEST1 is a Drill Down verticla mount that installs with minor drilling and bolting. Fits all vehicles with a vertical flat surface.

NOTE: Click here for Airbag Safety and RAM Mounting Systems.

NOTE: The base can be mounted on both sides of RAM 9", 13", 17" and 21" console boxes.

NOTE: For the vehicle base only see the RAM-VB-181 by clicking here.

Special Requirement: This system requires a flat vertical surface to mount the base properly.

RAM-VB-181-WEST1 Manufacturer Included Components:

NOTE: Manufacturer components can change without notice.

NOTE: Click the links below for pictures and detailed part information.

VESA Plate: Long sized arm with RAM-2461U VESA Plate. The RAM-2461U VESA Plate consists of a C size 1.5" rubber ball connected to a 3.625" square plate featuring a 75mm x 75mm VESA hole pattern. The rubber ball is positioned 0.88" from the center of one edge.
Swing Arm: RAM-VB-110-1U dual swing arms provide 12 inches of total horizontal extension.
Upper Tele-Pole: RAM-VP-TTMF12U 12 inch male upper tele-pole with flange.
Lower Tele-Pole: Integrated into vehicle base.
NOTE: Tele-poles feature a telescoping vertical height adjustment range from 7.75 to 12 inches.
Vehicle Base: RAM-VB-181 DRILL DOWN VERTICAL BASE.

RAM-VB-181-WEST1 Manufacturer Specifications:

NOTE: Manufacturer specifications can change without notice.

Warranty: Manufacturer's, RAM Mounts (National Products Inc.), Limited Life Time Warranty.
Material: Black powder coated steel.
Installation: Drilling into flat vertical surface is required for the vehicle base.
Mount/Base Placement: Vertical flat surface.
- NOTE: Vehicle base may limit seat travel.
Vehicle Base Dimensions:
- A = 3", B = 7.5", C = 2.029", Base Hole Centers = 3.34"
Back Plate Dimensions:
- A = 3.25", B = 1.5", Back Plate Hole Centers = 2"
Height Adjustability: Height can be adjusted from 7.75" to 12.0", depending on the upper tube size.

Instructions

Click here to view the RAM Mount Vehicle Laptop installation video.
NOTE: If your vehicle is equipped with an airbag sensor under the seat disconnect the sensor before installing the vehicle base. (If unsure contact your local car dealer.) The video shown is for installation reference and may show additional or less parts than your vehicle base (RAM stabilizer foot that attaches to the base/lower tele-pole as shown in the video). Simply follow the video without installing these components if your vehicle base does not include these parts. Your vehicle base may connect to the seat track bolts differently than shown in the video. The instructions shown to install the RAM tele-pole system, swing arm assembly and Tough Tray are the same for all RAM No-Drill laptop systems regardless of the vehicle base used.
NOTE: Click here to view Airbag Safety and RAM Mounting Systems (Adobe required).