This RAM No-Drill mounting system installs quickly and easily into the 2020-Newer Ford Police Interceptor Utility using the existing hardware of the passenger side seat rails. This configuration includes a 12” lower pole and 12" upper pole. Dual swing arms provide articulation for access to the mounted device. The round ball base attached to the end of the swing arm supports a variety of tablet and laptop holders, while RAM rubber ball and socket technology provides additional adjustability as well as shock and vibration isolation.
Hole Pattern:
4-Hole AMPS: 1.181" x 1.496"
3-Hole 120-Degree 1.812" Diameter
RAM-VB-206-SW2 vehicle mount system for the following vehicles:
Ford Police Interceptor Utility(2020-Newer)
NOTE: As auto manufacturers redesign vehicle models this base may or may not fit additional models. If you do not see your vehicle listed contact us or complete the product inquiry form by clicking here.
NOTE: Click here for Airbag Safety and RAM Mounting Systems.
RAM-VB-206-SW2 Manufacturer Specifications:
NOTE: Manufacturer specifications can change without notice.
-
Warranty: Manufacturer's, RAM Mounts (National Products Inc.), Limited Life Time Warranty.
-
Material: Black powder coated steel.
-
Seat Configuration: Bucket seats only. Call/email about bench seats.
-
Installation: No-drill installation. Attaches to existing seat studs.
-
Mount/Base Placement: Passenger side floor, in front of seat.
-
Vehicle Base Quick Disconnect: Optional. See RAM-VB-REM1 below.
-
Vehicle Base Dimensions:
-
Dimension A: 8.8 inches
-
Dimension B: 13.375 inches
-
Dimension C: 2inches
-
Center to Center Hole Seat Bolt Distance: 12.0 inches
-
NOTE: Center to Center Hole Seat Bolt Distance is the center hole distance of the two pre-drilled holes in the vehicle base that line up with the vehicle seat bolts. This distance MUST MATCH your vehicle.
