themountdepot.com

• Garmin Rino 520
• Garmin Rino 520HCx
• Garmin Rino 530
  
• Garmin Rino 530HCx

Note: This mount assembly WILL NOT FIT the Rino 110, 120 and 130 Series. The RAM-HOL-GA8U is needed for the Rino 110, 120 and 130 series and can be viewed by clicking here.

NOTE: As the manufacturer adds new units/models to the above series this cradle may fit additional models not listed above. Please call 224-578-9162 or complete the product inquiry form by clicking here.

RAP-B-104-224-GA20U shown above.

RAP-B-104-224-GA20U Includes the Following:

• Warranty: Manufacturer's, RAM Mounts (National Products Inc.), Limited Life Time Warranty.
• Mount End Plate Design: The RAP-B-238 high strength composite universal plate has a 1.0 inch diameter rubber ball connected at right angles to a 1.25 x 2.5 inch diamond plate. The plate has two holes positioned 1.9 inches from center hole to center hold and compatible with the AMPS hole pattern.
• Mount Arm Design: The RAP-B-200-1 socket and octagon button arm includes a 1 inch B sized ball socket and is made of high strength plastic. The arm is 1.75 inches long when measured from socket center to button socket end. The side of the arm includes a tightening knob which allows you to open and close the socket ends.
• Mount Base Design: The RAP-224-2 high strength plastic locking 3.25 inch diameter rubber suction cup base is designed to have an extra strong hold on any smooth non-porous surface. With a twist on the locking knob, the suction cup base adheres to any glass or non-porous plastic surface. Connected to the top of the RAM suction cup is a male RAM plastic octagon button with pivot connection. The pivot design allows the mount to tip from 0° to 90° to the suction cup, while the octagon button connections allows the arm to rotate 360°. The button end connects directly to a RAP-B-200-1 composite arm with socket and female button ends.
• Cradle: RAM-HOL-GA20U high strength plastic cradle is designed to hold the Garmin device specified above. Place the top of the GPS unit into the cradle, and then push the base into the expandable arms at the bottom of the holder. The arms will then snap into place when the GPS is completely secured in the cradle. The cradle allows all cables (not included) to stay connected while the GPS unit is in the cradle.
  

• Optional Cradles (NOT INCLUDED): To view additional optional compatible cradles for Apple, cell phone or GPS units click here.