Description
The RAP-SB-180-AP10U is a simple and attractive adhesive base mount designed for the following models:
- Apple iPod Touch 4th Generation
NOTE: The cradle WILL NOT FIT 1st, 2nd, 3rd generation Touch models or Touch models with a case, bumper or skin.
NOTE: As the manufacturer adds new units/models to the above series this cradle may fit additional models not listed above. Click here for the most current model information RAM-HOL-AP10U. Please call 224-578-9162 or complete the product inquiry form by clicking here.
RAP-SB-180-AP10U shown above.
RAP-SB-180-AP10U Includes the Following:
Warranty: Manufacturer's, RAM Mounts (National Products Inc.), Limited Life Time Warranty.
Description: Minimalists in design yet incredibly useful is the RAM Lil' Buddy mount. Using an adhesive disk, put the Lil' Buddy practically anywhere you want to keep your portable electronics easy to see and always within your reach. Designed with a very small foot print, finding a home on your dash or console is easy.
Base: 2.5 inch adhesive disk base.
Arm: Composite arm that attaches to the adhesive disk base.
Adapter: Composite black powder coated universal diamond plate. Two holes measuring 1.9 inches from center to center is compatible with the AMPS hole pattern and any RAM Mount holder. This mount rotates 180 degrees.
Cradle Description: Included RAM-HOL-AP10U high strength plastic holder for the device(s) specified above. Place the top of the device into the cradle, and then push the base into the expandable arms at the bottom of the holder. The arms will then snap into place when the device is completely secured in the cradle. The cradle allows all cables (NOT INCLUDED) to stay connected while the Touch is in the cradle.
Optional Cradle (NOT INCLUDED): Additional cradles for Apple, cell phone or GPS holders can be found by clicking here.
Features
- General recommendations to properly adhere the adhesive disc.
- Ensure that both the dashboard surface and the bottom of the Ram Mount base have been thoroughly cleaned and dried.
- Attach either side of adhesive to the base first, let it sit several hours to allow adhesive to thoroughly bond.
- Attach other side of adhesive (with base) to the dashboard surface.
- Let the adhesive disc sit several hours before adding socket arm components, etc. to allow the adhesive to properly bond to the dashboard surface.